Home > News

Three Important Indicators of Wire and Cable Quality Testing

Jul. 03, 2019

The selection of qualified wire and cable products is related to the safety of people's production and life. For ordinary consumers, in addition to knowing how to select qualified wire and cable products, it is necessary to understand the general monitoring knowledge of wire and cable. Insulated Mineral Sheathed Cable Manufacturer believes that there are several important indicators in the quality inspection of wire and cable.

1. Test of insulation resistance:

Insulation resistance reflects an important indicator of the insulation properties of wire and cable products. It is closely related to the electrical strength of the product, the dielectric loss, and the gradual deterioration of the insulation under working conditions. For the communication cable, the insulation resistance between the lines is too low, which also increases the loop attenuation, the crosstalk between the circuits, and the long-distance power supply leakage on the conductive core. Therefore, the insulation resistance should be higher than the specified value.

Mining Cable for Sale

2. Measurement of capacitance and loss factor:

When the cable is connected to the AC voltage, current flows. When the amplitude and frequency of the voltage are constant, the magnitude of the capacitor current is proportional to the capacitance of the cable (Cx). For ultra-high voltage cables, the current of such capacitors may reach a value comparable to the rated current, which is an important factor limiting cable capacity and transmission distance. Therefore, the capacitance of the cable is also one of the main electrical performance parameters of the cable.

3. Partial discharge measurement:

There is basically no local power generation for oil-filled cables; even if the oil-paper cable has partial discharge, it is usually very weak, such as several PCs, so these cables may not be tested for partial discharge in the factory test. For the extruded cable, not only the possibility of partial discharge is large, but also the damage of the partial discharge to the plastic and the rubber is serious. As the voltage level increases, the work field strength increases, and the problem becomes more serious, so the high voltage Extruded cables are tested for partial discharge during factory testing.

For more information on Mining Cable for Sale, please visit our website at https://www.sino-cables.com



Chat Now
Jennifer leo